English
This yacht is a prime example of the Southerly 110 built at Itchenor, which has been designed for family cruising, having excellent accommodation and facilities. This high specification yacht has been well maintained by the current owner, with many improvement and upgrades having been carried out over recent years. Southerly models are highly sought after and we would therefore recommend contacting us to arrange an early viewing.
Dimensions
Length Overall 10.82M 35ft 6 ins
Lengths Waterline 9.22M 30 ft 3 ins
Beam 3.57M 11 ft 10 ins
Draft, keel up 0.72M 2 ft 4 ins
Draft, keel down 2.18M 7 ft 2 ins
Displacement 6,980Kg 15,388 lbs
Ballast weight 2,205Kg 4.455 lbs
Keel weight 1,050Kg 2,310 lbs
Total Ballast 3,255Kg 6,765 lbs
Air Draft 14.00M 45 ft 11 ins
Fuel tank 182L 40 Gal
Water tank 205L 45 Gal
Holding tank 56L 12.4 Gal
Hull Construction
Heavy duty GRP Moulding, hand laid to Northshore Nordseal laminating system incorporating multi-axial and unidirectional reinforcements. Thickness increases progressively towards the keel area. The keel box is an integral part of the hull lay-up and sandwich construction stiffening runs the entire length of the hull topsides. All main bulkheads are bonded into the hull.
Gelcoat colour: Oxford Blue
Boot top stripes: Red & white
Style lines: Red and white
Underwater finish: Antifouling
Deck Construction
Hand laid GRP. Sandwich type construction using balsa core stiffening , with marine plywood in high stress areas where fittings are positioned. Heavily stressed areas are additionally reinforced with unidirectional glass reinforcement, The deck is bonded to the hull through the entire length and to all main bulkheads resulting in a strong an integrated unit. Teak cappings are used to cover the hull to deck joint upstand
Gelcoat colour: Ivory White 9010
Ring deck: Non Slip two tone surface, in biscuit
Swing Keel
The fixed ballast is an iron casting which acts as a grounding plate and as transverse stiffening for the keel unit. It is fitted into a recess in the hull in the area of the keel box with stainless steel bolts. The aerofoil swing keel is cast iron and incorporates a stainless steel pivot at the leading edge. The swing keel is raised and lowered by a hydraulic ram powered by an electrically driven pump with a manual back up. All hydraulics are easily accessible for maintenance. A keel control panel and gauge showing keel position is fitted at the wheel pedestal. A removeable stainless steel pin positioned to enable the keel to be locked in the “UP” position.
Engine
Yanmar 3YM30 21.3kW (29hp) 3 cylinder fresh water cooled diesel engine, with quick change diesel pre-filter and trap. New water pump fitted 2022
Reduction/reverse gear
110amp high output Balmar alternator and regulator 2020
Bronze stern tube with water PSS dripless shaft seal. Cutless bearing replaced 2020
Stainless steel propeller shaft
Bronze three bladed Brunton Autoprop propeller
Ambassador AM10 rope cutter fitted on prop shaft
Substantial skeg fitted on centreline to protect propeller and rudders when yacht is dried out
Non-metallic fuel tank under cabin sole below chart table – capacity 182 litres/40 gallons, with sediment trap and line filter
Non-metallic water strainer with removeable filter
12V electric ventilator
Sound deadening to engine box
Hinge up panels at either end of engine box for access
Engine box can be completely removed for maintenance.
Bow Thruster
55 kg thruster with control at cockpit steering pedestal
Electrics
12 Volt system
Three heavy duty 110Ah 12v lead carbon batteries for domestic services (new 2022)
One Heavy duty 110Ah 12v lead carbon battery for engine (new 2019)
One 110Ah battery for generator
Victron SMV 700 battery monitoring system
Victron Multi plus combi charger/Inverter
Isolating switches
Cabin lighting throughout
Reading lights over bunks
Chart light ever navigation table
Full navigation light system, incorporating bow light, stern light, masthead tricolour light with all round white anchor light, deck flood light and steaming light.
Circuit breakers on main panel
12V Interior socket
240V Ring main, with 3 double socket outlets (1 each in galley, saloon and aft cabin). With earth leak circuit breaker and shore power connection lead with plug, plus extension lead
240v 1Kw immersion heater fitted to hot water calorifier
Ficher Panda 5000i 5Kw 240V inboard generator fitted in cockpit locker (2021)
12V 25amp socket (for high load applications) fitted to instruments panel above companionway
Navigation and Electronics
Radar reflector fitted to mast
Raymarine ST60+ speed, depth and wind indicators mounted in instrument panel above companionway hatch
Raymarine autopilot with Mamba drive, ST6002+ displays, one mounted on steering pedestal, the second mounted at chart table
Raymarine RAY240 VHF radio completed with handset and speaker at chart table. Remote handset and speaker mounted in cockpit
VHF Aerial and wind indicator fitted at masthead
Raymarine Axiom RV9 touch screen chart plotted/sonal at helm (New 2022)
Raymarine AIS receiver and transponder (New 2023)
Raymarine Raystar 125 GPS receiver
WiFi booster system
Radio/CD/MP3 stereo system with two speakers in saloon
Additional waterproof external speakers fitted to cockpit
15” LCD flat screen tv with built in Freeview and DVD player fitted to forward salon bulkhead
Glomex TV antenna fitted at masthead
Engineering
Diesel powered hot air heating system with three outlets, fore cabin, saloon and aft cabin
Top loading refrigerated ice box in galley (75 Litre capacity)
Holding tank system fitted to toilet. Heads pumps to sea or into tank
Water System and Pumps
Pressurised hot and cold water system
Mixer tap to galley sink
Filtered water faucet to galley sink
Mixer tap in heads compartment
Non metallic water tank under aft end of dinette – Capacity 205 litres/45 gallons
Hot water provided by engine calorifier unit
Electric sump pump to shower tray
One manual bilge pump
One electric submersible bilge pump
Steering
Semi balanced twin rudders
Pedestal mounted stainless steel cockpit wheel
Lewmar/Whitlock Cobra steering system
Single lever engine control
Emergency steering system
6” main steering compass and compass guard
Spars and Rigging
Selden tall fractional rig, with in-mast furling
Selden anodised aluminium spars finished in silver
Internal halyards
1 x 19 stainless steel wire standing rigging with swage toggle fork chrome bronze rigging screws. Standing and running rigging replaced in 2019
Furlex headsail reefing system
Single line reefing led to aft cockpit for mainsail
Selden boom with kicker and anti-gibe boom brake
Kicker, main halyard, topping lift and 2 reefs lead aft
Genoa halyard at mast
Burgee and signal halyards
Sail control lead aft across pilot house
Lewmar size 8 winch on mast
Removeable stainless steel bowsprit
Pole with topping lift with mast stowage
Sails
Furling self tacking Jib with UV protection strip (new in 2019)
In-mast furling mainsail with full vertical battens (new in 2020) Plus spare mainsail in good condition
Furling asymmetrical gennaker with Bartels furling gear
Cockpit
Aft cockpit
Teak laid cockpit seats
Teak laid cockpit sole
Teak to cockpit coamings
Self draining
Good access aft for boarding through transom
Telescopic stern boarding ladder
Deep lazarette locker to port
Shallow drained lazarette locker to starboard
Gas bottle stowage in cockpit locker
Cave locker in starboard cockpit coaming
Sliding acrylic companionway hatch with hinged acrylic washboards
Stainless steel grab handles to companionway
Stainless steel locking bar for companionway
Instrument panel above hatchway
Two winch handle pockets
Steering pedestal
Wheel and pedestal cover in Sunbrella Captain Navy canvas
Folding white cockpit table fitted forward of pedestal
Steering wheel rim hide covered
Cockpit cushions I blue canvas with white trim
Two safety harness eyes
Cockpit spray hood in Sunbrella Captain Navy canvas, with hide covered grab bar
Deck Fittings and Loose Gear
Cleats forward and aft raised
Spring cleats amidships with stainless steel chafe guard
Fairleads aft
Stainless steel stemhead fitting with twin bow roller
Reinforced foredeck for anchor windlass
Quick Crystal 1000 12V windlass with hand held remote control and additional manual switch on Steering pedestal (New motor fitted 2022) Isolation switch in forecabin
Stainless steel pulpit incorporating navigation light bracket
Stainless steel stanchions and guardwires, with midship gates port & starboard
Stainless steel pushpit incorporating stern gate, navigation light bracket and ensign socket
PVC coated harness lifeline jackstays port and starboard
Fuel and water deck fillers
Sheet turning blocks to take Furlex line, clutch on side deck
Mainsheet track with control lines in cockpit
Clutches on each side for running rigging
Two Lewmar 46ST winches at companionway
Two Lewmar 30ST winches
Stainless steel grab handles on either side of the coachroof
10 Kg Rocna anchor
50 Metres of 8mm chain
50 Metres of rope warp
Anchor snubber and anchor ball
15Kg Bruce kedge anchor
Outboard bracket fitted to sternrail
Weaver snap davits fitted to transom
Telescopic folding swim ladder fitted under transom step
Three fire extinguishers
One fire blanket
Mooring warps
Fenders with quick clip hangers
Boathook
Ensign and staff
Horseshoe lifebuoy with light
Seago MOB Rescue and Recovery system
Plastimo 6 man canister liferaft in deck mounted stainless steel cradle mounted to coachroof (Serviced 2021/05)
Windows, Hatches and Ventilation
Size 60 opening deck hatch over forecabin
Two size 1 opening portlights in cockpit to serve aft cabin
Two dorade ventilators on deck serving heads and galley
Acrylic sliding companionway hatch
Hinged acrylic washboard doors
Pilothouse windows and hull ports are partially reflective toughened glass bonded into recessed in the GRP mouldings
Interior Joinery and Upholstery
Internal joinery is finished in solid wood with faced marine quality plywood
Linings are fabric covered plywood and GRP moulding as appropriate
Cabin soles are teak striped non-slip laminate
Joinery: American Cherry
Galley worktop: Corain type “Desert Mist”
Saloon upholstery: Cristana Marrone Prima Vera 80
Navigation seat: Chocolate leather
Cabin upholstery: Cristina Marrone Prima Vera 80
Curtains to hull portlights: JAB Fresco 1-6145-666
Accommodation
The layout is in accordance with the general arrangement drawing. There are a total of eight berths, with three in the forecabin. two in the aft cabin and three in the saloon (A double berth conversion and single settee)
Galley
Raised galley to port
Twin stainless steel sinks
Hot and cold pressurised water
Filtered drinking water tap (New 2019)
Corian type worktop
Top loading refrigerated ice box, 75 litres, re-gassed and new thermostat fitted 2021
Stainless steel grab rail to worktop
Fully gimballed Tasman 4500 gas cooker with two hob burners and grill, with fail safe devices on all burners (New 2021)
Samsung 28L combination microwave oven (New 2021)
Gas cut off tap
Waste bin below
Two large opening lockers
Four drawers
Stowage under side deck
Overhead lighting
Saloon
Dinette seating arrangement to port
Two lockers forward
Stainless steel mast support, with sliding table (converts seating area to double berth)
Full length single settee to starboard
Stowage under and front access
Bottle stowage
Recessed lights under side decks
Overhead lights
Four fixed hull port lights
Curtains to hull port
Electronic digital Barometer
Tide clock
Navigation area
Chart table to Starboard with excellent visibility
Chart stowage under hinged lid
Book stowage below
Seat with stainless steel grabrail
Large stowage under seat
Chart light
Main switch panel
Overhead deck light
Aft cabin
Large double berth offset to starboard
Large vanity unit to port with angles acrylic doors, stowage under and outboard
Two Drawers
Locker
Shelved wardrobe
Stowage drawer under forward end of double berth
Reading lights
Overhead lights
Two fixed hull ports
Two opening ports to cockpit
Doors to ensuite facilities
Access aft through bulkhead to steering gear
Heads
Heads compartment to starboard of companionway
Electric operated marine WC
Hinged seat to cover marine toilet
Washbasin with corian type worktop
Showerhead/mixer tap
Stainless steel grab handle
Hot and cold pressurised water
Stowage under and outboard with acrylic doors
Shower fixing
Electric shower waste pump
Grating to shower tray
Mirror
Fixed light
Waterproof toilet roll holder
Oilskin stowage
240V Electric towel rail
Forecabin
Single berth to port that convert to a double for sleeping
Overlapping berth to Starboard
2 Lee cloths
Full length shelf to port
Locker aft
Hanging locker to starboard
Access to chain locker through forward bulkhead
Two fixed hull ports
Opening deck hatch
Overhead lights
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.